Series Generator
Check out this page if you are looking for Series Generator
 |
 Power Train 4500W 5500W Xtreme Contractor Series Generator 9HP Engine NIB  US $399.00
|
 3500 Series Gas Powered Generators US $325.00
|
 Onan 75 KW Generator JB JC Series US $1,295.00
|
 Briggs and Stratton 030209 Elite Series 5500 Watt Portable Gas Generator US $499.97
|
 LIFAN PRO SERIES 3750 GENERATOR US $425.00
|
 Cat and Generac 48kw Standby Generator Olympian Series US $9,999.99
|
 Generac GP7500E GP Series Portable Generator 5943 US $1,199.99
|
 Kipor IG3000 Inverter Generator new series for 2011 US $1,348.54
|
 Kipor IG4300 Inverter Generator new series for 2011 US $2,131.35
|
 Portable Gas 3500 WATT ELITE SERIES GENERATOR BRIGGS US $599.99
|
 Onan DFY Series Spec B Generator Parts Catalog Manual US $22.03
|
 Onan Model DYG Series Spec A G Generator Parts Manual US $22.03
|
 OEM Onan DFE Series Spec K Generator Operators Manual US $22.03
|
 OEM Onan DFS Series Spec C Generator Operators Manual US $22.03
|
 OEM Onan DFP Series Spec K Generator Operators Manual US $22.03
|
 Commercial Series Heavy Duty Generator Hyundai HCP9000 US $2,100.00
|
 HCP6500D Diesel Generator Hyundai Commercial Series US $2,300.00
|
My Generator turns over but won't start. What should I do?
I got the Onan Microlite 4000 series generator with an RV, and it has not been started for some time. I've replaced the spark plug and tested that it has a spark. Also I inspected the carburetor (it was clean) and drained it of old gas. I used fresh fuel and drained the lines of tho old fuel. The fuel pump is working well. I also gave it an oil change and filled it properly. Anything else I can do?
Before you attempt to run this, get some wd40 or PB blaster (my fav) spray it down the spark plug hole and turn it over to lube and break up any rust formations that may have occurred . Replace the plug, spray the ether starting fluid down the carb and it should start.
I leave my lawn mower outside all year long and the in spring the ether starting fluid works beautifully. It stumbles for a minute or two then smooths out.
If it has compression, spark and fuel it should turn over. I surmise there may be improper atomization from the carb due to varnish forming in the old gas.
Try some starting fluid down the carb throat. If it turns over the carb needs cleaning out. IF it doesnt its possible you may have spark but insufficinet compression. It could be the rings have stuck in the piston grooves and caused poor compression.
Comments